cross-posted from: https://infosec.pub/post/51092505
I have a 3-pin Dell PSU spec’d as 19.5v 3.34A and DMM measures at 20v unloaded. The power reqs on the HP laptop are 19.5v 3.33A. AFAICT, that’s a match. Even the 3-pin barrel connector geometry matches. So what’s the problem?
The center pin is a “smart pin” aka “data pin”, as I came to learn. According to @over_clox@lemmy.world, this PIN basically passes brand info so HP can reject non-HP PSUs. But according to this article, the data pin is used to “regulate” the voltage – which I take to mean it negotiates the voltage for transmission as USB-PD does. If it’s merely negotiating power reqs, then the Dell should work.
It’s possible both sources are correct… perhaps HP has its own proprietary way of negotiating voltage and Dell has theirs.
Someone even claims that the data channel is used to communicate temp info so a PSU does not overheat. If that’s true, then perhaps it was a good design (noting that the USB-PD standard did not emerge yet).
But is it true about the communication? Considering there are hacks with a resistor or something to satisfy the data channel, it’s hard to believe that the communication is that sophisticated.
This page advises HP owners to always buy HP-branded PSUs. But it’s unclear if that’s just overly safe nonsense.
12V is optional now. It was part of PD revision 1.0 and dropped in later revisions, but many chargers still support it. 9V has been required since PD rev 2.0.
With the device that uses the 9V only USB adapter, I would either glue the plug in or replace it with something else. Its too easy to accidentally fry something with that.