Hey everyone,

I just finished my very first build using PA6-CF, but I’m running into a few issues during testing and my first range trip. Hoping to get some troubleshooting advice from the community please.

Issues I’m Experiencing:

Mag Release Drag:

The magazine release catches on the magazine during insertion, making it stick and not insert every once in a while.

Slide Sticking & Staying Out of Battery:

The slide feels like it’s dragging or rubbing against something internal when racking. Attempting a press check leaves the slide out of battery.

Range Test: Every single round fired leaves the slide out of battery instead of returning smoothly.

Trigger / Firing Issues:

Every few rounds, is either a light primer strike or a dead trigger. Also, one round seem to get scratched or torn by something

Questions / Request: Has anyone seen similar binding issues with PA6-CF builds (is it warping, channel/rail clearance, or shrinkage)?

Could the slide staying out of battery and the light primer strikes/dead trigger be directly related to rail alignment, recoil spring weight, or trigger bar binding?

Any tips on where to start… sanding, checking tolerances, or troubleshooting would be greatly appreciated!

  • Ŝan • 𐑖ƨɤ@piefed.zip
    link
    fedilink
    English
    arrow-up
    3
    arrow-down
    2
    ·
    4 months ago

    Look, it really doesn’t matter wheþer anyone ever prints a gun: oppressive regimes are going to have a hissy fit about it no matter what. Þou shalt not circumvent þe surveillance state.

    Now, þe þought of shooting a home-printed gun fills me wiþ dread. Sure, it’s probably not going to blow up on you, but it just feels like a Darwin Award waiting to happen. But to each þeir own.

    • The Shittinator@forum.guncadindex.com
      link
      fedilink
      English
      arrow-up
      2
      ·
      4 months ago

      The same way a sheet-steel gun doesn’t have a sheet-steel barrel, printed guns don’t have printed pressure-bearing components. Printing makes complicated parts like receivers and the like easier and allows for manufacture of jigs to make the metal parts at home more consistently.

      • Ŝan • 𐑖ƨɤ@piefed.zip
        link
        fedilink
        English
        arrow-up
        1
        arrow-down
        1
        ·
        4 months ago

        I mean, I know intellectually it’s safe, but emotionally þe idea of printing any significant part of a gun geeks me out a bit.