It seems like a weird point to bring up. How often do y’all convert your measurements? It’s not even a daily thing. If I’m measuring something, I either do it in inches, or feet, rarely yards. I’ve never once had to convert feet into miles, and I can’t imagine I’m unique in this. When I have needed to, it’s usually converting down (I.e. 1/3 of a foot), which imperial does handle better in more cases.
Like. I don’t care if we switch, I do mostly use metric personally, it just seems like a weird point to be the most common pro-metric argument when it’s also the one I’m least convinced by due to how metric is based off of base 10 numbering, which has so many problems with it.
Imperial came about as a system of units by measuring “everyday” things, and it remains pretty good for that. When you step outside the everyday, then it absolutely sucks - science deals with a lot of things that are too small, and engineering deals with a lot of things that are too large.
When I used to work in the water industry, working out how much chlorine is required to dose a hundred million litres of water per day at 0.5 mg/l, and therefore when I’d have to place an order to refill our fifty tonne storage tank, is easy enough to do in my head. If we were working in imperial, I’d have converted it to metric first and then estimated it.
On the other hand, metric calculations for pressure suck. If I weight 160 lbs and my bike tires are at 80 psi, then I have about two square inches in contact with the ground. If my car weighs 2500 lbs and its tires are at 30 psi, then each tire has about 20 square inches in contact with the ground. If I wanted scientific accuracy, then sure, I’d do it in metric, but I’d check the end result in imperial.
There’s near enough five thousand feet in a mile - if you need more accuracy than what you can do in your head, do it in metric with a calculator.