I have a Mitsubishi Electric “MSZ-GL06NA”.

The vanes seem to not move at all, regardless of any position.

The vane motor makes no noise either that I can hear.

Mitsubishi Electric doesn’t provide on the phone help for end users.

And the internet is full of SEO spam.

I tried:

  1. Cutting the power for 1 minute.
  2. Setting vane to open / close and doing #1

Is there an external reset button perhaps, what else should I do for troubleshooting?

Edit 1: Solution found! Steps:

  1. Turn breaker off
  2. Remove front panel
  3. Remove Motor
  4. Twist motor to extremes then back to “closed”
  5. Remove motor wires and reseating
  6. Putt all back together
  7. Turn breaker back on. https://lemmy.ml/comment/18994396
  • Clocks [They/Them]@lemmy.mlOPEnglish
    15·
    5 days ago

    I just opened it up, reseated the connector wire.

    I also disconnected the motor completely and gave it a twist from vane fully opened to closed.

    The controller board is covered in a hard to open plastic shell, I have little interest in breaking it to figure out which prongs should have been pushed, so scratch diagnosing the board…

    AHAHAHAH IT WORKED, MOTOR WIRE NEEDED RESEATING!