I’m super curious about both the intended outcome and this one pictured. 🤩🤘🏼
This was the intended outcome. I got some new inks and thought one looked like coffee and I was pretty sure that the petri method would look like cream in it.
Ok. I’ll go look up “petri method”, thanks. 🤓
It’s simple to understand but takes trial and error to get working. You use a “sinker” ink to cause other inks to sink through the resin. The ink I’m using, after a bunch of YouTube recommendations, is piñata blanco blanco.
Fill your mold about 90% to 95% and then add two drops of a color and then 2 drops of the sinker, then do it again so you have layers of color, white, color, white. Let the alcohol sit for a little bit to evaporate and then cover the dyes with any remaining resin. Everything at the surface will kinda mix together but the inks are already sinking below. Let it cure and see what you end up with. Give it extra time to cure before any sanding or polishing because the excess ink will slow the process down.
Don’t use too much white or a lot will sink to the bottom and create a soft spot that won’t fully cure.
That IS super helpful, thanks! 🤩
looks almost like the underside of a mushroom
That’s why it’s called petri, looks like some kind of fungus growing in a Petri dish.
Ah I wasn’t totally sure I knew how to spell petri so I wasn’t sure if it was refuring to a petridish
I can’t ever get white alcohol ink to do me justice. What am I missing?
I’m using piñata blanco blanco. I didn’t really believe it but all the other whites (3 to be specific) I tried did not work as well. I did 2 drops of ink, then 2 drops of piñata and I did that twice for each die.
Most of my previous experiments were just with extra resin in a dump mold so I didn’t really count them. I had one that looked promising but when I tried it in dice it didn’t work well at all, just kinda sat near the surface and only slightly penetrated downward.
Reminds me of The Fountain.
Loved that movie